You can wire up to 8 zones with one Retrofit Alarm Kit. This is intended to tolerate 4.7K, 1K or 2K end of line resistors commonly found in wired systems.Īdd Up to 8 Zones at a Time. The Ring Retrofit Alarm Kit design supports a maximum resistance of up to 5200 ohms under all conditions of temperature, battery, etc, with or without end of line resistors. Check your alarm panel and documentation to confirm compatibility. To see if the Ring Retrofit Alarm Kit will work with the contact sensor zones wired to your alarm panel, you’ll need to verify the resistance on your zones. Note: Your Ring Alarm or Alarm Pro Base Station will need to be connected to the internet via wifi or ethernet, and cannot be on cellular backup during the Retrofit Alarm Kit installation.Ĭompatibility. If you purchased your Retrofit Alarm Kit as a bundle, first set up the Ring Alarm or Alarm Pro Base Station before starting this installation. You need to have a Ring Alarm or Alarm Pro Base Station set up at your location before you begin to add the Retrofit Alarm Kit and connect it to your wired contact sensor zones. Learn about the technical specifications of compatible zones. Get to know the anatomy of a wired alarm panel and understand supported sensor types. We suggest that before you begin installing the Retrofit Alarm Kit, you take a few moments to review these alarm panel basics and identify the layout of your own wired alarm panel. This device is designed to operate in a particular region and is not intended to be used or distributed outside of that region. You are also responsible for any changes or damage to your existing alarm system. You are responsible for ensuring that you do not have any existing contractual obligations regarding your existing alarm system. If you are not comfortable or are inexperienced with the processes and tools described in these instructions, we recommend that you hire a licensed electrician or professional alarm installer. Working with electricity can be dangerous unless proper safety precautions are taken. Note: These instructions are for informational purposes only. Do not attempt to install the Ring Retrofit Alarm Kit yourself. Disconnecting power will result in the deactivation of your hardwired life safety devices. If you are using hardwired smoke, CO, or heat detectors* or other life safety devices, we strongly recommend that you get a licensed professional to do any work on your wired alarm panel. We advise you not to install this yourself if you are inexperienced in any of these areas. Professional alarm installers and licensed electricians are experienced with wiring projects, are familiar with using tools such as multimeters to test electrical wiring, and can read and interpret electrical schematics. We recommend that you consult a professional before installing the Retrofit Alarm Kit. Note: Please read all of the following instructions before you begin the installation. Learn how to install your Ring Retrofit Alarm Kit. Back Ring Retrofit Alarm Kit Installation Instructions
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |